1/20/2024 0 Comments Auto glock conversion plansIf your Glock handgun fires full auto in BOTH selector rod positions, disassemble the device and follow the instructiOllS on the modification page. The dlsconnector must create a small channel in the frame to allow the slide to operate freely. If this is still not the cause, please repeat step 5. If the device is unseated even a fraction of an inch, it will cause your slide to not dose all the way. Then check to see that the device Is FUllY seated In the end cap slots. If your Glock slide does not close fully: First check to make sure you do not have extra parts left over] Only the black plastic end cap should be extra. Once the positions have been committed to memory, it is time to test fire your new Glock handgun! Refer to the previous photos for setting the selector switch to semi or full-auto fire. Now use the screwdriver to push back the small spring loaded extractor plunger to allow the fully assembled device to fully seat Into the end cap slots.ĥ) The last step before test firing Is to pull and release the slide ten to twenty times to create a small channel for the disconnector in the frame. Slip the assembled device Into the empty end cap slots. Now use the small screwdriver to again lever the plastic firing pin jacket away from the metal Mng pin notch. Note the small spring loaded extractor plunger that Is now exposed.Ĥ) Assemble the full -auto device and set aside. While your are holding back the firing pin jacket, remove the black plastic end cap by lifting it out or prying it out. Use the small screwdriver to lever the plastic firing pin jacket away from the metal firing pin notch. A small screwdriver or pointed key is all that is needed to remove the black plastic end cap on the rear of your Glock slide.ģ) Position the small screwdriver between the metal firing pin notch and the plastic firing pin jacket. While you may prefer to, it is not necessary to remove the slide to install your full-auto modification device. Now, knowing and agreeing with this truth, please remove your Glock magazine AND the CHAMBER ROUND befOO!: beginning the assembly steps.Ģ) Pull back the slide of your Glock handgun and lock it open by applying upward pressure on the slide release. INSTALLATION PROCEDURE (providing you have ATF approval)ġ) No one has ever been accidently shot while servidng an unloaded fireann.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |